Vibration sensors
For standard measurements or modal analysis single axis, I1T-50g-1 and isolated triaxial I3T-50G-1 IEPE cube accelerometer with 50 g range is recommended.
I1AI-500G-1 is a miniature accelerometer intended for measurement of higher vibration up to 500g.
Accelerometers are equipped with TEDS smart sensor interface. DEWESoft software automatically detects the sensor and sets correct scaling.
All our vibrations sensors are fully compatible with our vibration shakers line.
Industrial accelerometers
Case isolated sensors can also be used with non-isolated amplifiers without worrying about ground loops.
I1TI-50G-2 IEPE sensor is perfect for industrial application due to its rugged case and connector. I3TI-50G-1 is a standard triaxial sensor with to 50 g range. I1TI-500G-1 is a single axis accelerometer that can measure up to 500 g.
C1T-50g-1 charge accelerometer can be used in high-temperature environments up to 190 deg. C. 
Modal impact hammer
Complementary to vibration sensors the IH-441N-1 modal hammer with up to 440 N range is a perfect fit for modal analysis applications using the Dewesoft software.
Modal hammer is equipped with TEDS smart sensor interface. Dewesoft X software automatically detects the sensor and sets correct scaling.
Angle sensors
Angle sensors can be used for measurement of rotational angle and velocity. Sensors can be directly connected to any counter input on SIRIUS, MNITAURs or DEWE-43.
- DS-TACHO1 is isolated tacho sensor with variable threshold and up to 100 V input signal.
- DS-TACHO2 is optical tacho sensor for up to 1 m distance and 4 kHz bandwidth.
- DS-TACHO3 is long-range laser tacho probe for up to 7.5 m distance and 4 kHz bandwidth.
- DS-TACHO4 is high-frequency tape and tacho laser probe for up to 100 kHz bandwidth and 2-5 mm distance.
